Buy Low Price From Here Now
Stack dado set has anti kickback, splinter free cuts, negative hook angle for flat bottom grooves. Can be used on table saws, radial arm saws for cutting slots, grooves, dadoes, and rabbets in plywood, hard, and softwoods. Includes: (2) outside blades, ca
Readmore
Technical Details
- An ideal dado set for smooth, flat-bottomed grooves- Provides splinter-free cuts
- Anti-kickback design
- 5/8-inch arbor
- Limited lifetime warranty
See more technical details
By F. Kirk (Atlanta, GA)
Maybe I shouldn't complain; I got this product on sale. However, everytime I cut a dado I have significant tear out on the back side of the cut and the bottom is ANYTHING but smooth - so I smooth it with a float. Also, the plastic holder broke, but I suppose that is just the way plastic containers are. As the other reviewers mentioned, hang on to your instructions - they are just a small piece of cardboard. If I had it to do all over again, I would read the other product reviews and invest in a higher priced dado set and hope that the bottom of the cut is close to being smooth. There are a lot of folks that like this product, so maybe I just got a lemon.
By Jordan H. Shatsoff (Waltham, MA)
The cuts from this dado set are great. It's perfect for a portable saw like the Ridgid TS2400. The lack of markings on the shims are a minor nuisance, but using them gives excellent results.
By Rick A. Gifford (West Virginia, USA)
Ihave used this set for several projects now. The instructions are clear for the settings, and so far I have found them to be very accurate.
I think this is a good set. I would hate to go back to my old set with shims.
I picked this up on sale. Keep an eye on it as the price goes up and down. You can find this on Amazon at a reduced price if your lucky.
By New England Yankee (Northern New England)
Great dado set - very high quality, flat-bottom dados. It does not fit the Jet Xacta Saw Deluxe tablesaw, however. While the tablesaw's dust shroud does have a semi-circular cutout, it is not big enough to accommodate the dado set's dial. If possible, you should check for fit on any saw with such a shroud before buying.
By J. Dubovsky (Blacksburg, VA USA)
I've used this extensively on my Grizzly 1023 table saw with great results. I would highly recommend this blade set to anyone. My advice on using it:
* when you unbox the blades, measure the chipper thicknesses and label them "A", "B", "C", etc., according to the manual. There one that's thinner than the others, and it is required for certain thickness combinations; identifying it by sight is almost impossible. I wrote on them in silver Sharpie and it solved that problem.
* mark the "zero" on the thickness adjusting dial. Turn it until the back of the dial is perfectly flush with the back of the blade and write a "0" above that tick mark (again, silver Sharpie works great). That way, when the manual says "a 1/2 inch dado is these three blades plus four clicks" you'll know that you're really at four and not, say, three or five.
Images Product
Buy Freud SD206 6-Inch Professional Dado Now
0 comments:
Post a Comment